Studer-innotec HPC 2800-12 Bedienungsanleitung Seite 1

STUDER INNOTEC TEL : ++41 (0)27 205 60 80 Rue des Casernes 57 FAX : ++41 (0)27 205 60 88 CH – 1950 Sion E-MAIL : [email protected] User’s and

STUDER INNOTEC HP-COMPACT HP-COMPACT V5.4 12/80 charge, the same slide switch can be set in ON position. In case of doubt leave the setting in OFF p

STUDER INNOTEC HP-COMPACT HP-COMPACT V5.4 13/80 including the battery. If after the fuse replacement and after re-connection of the battery with the

STUDER INNOTEC HP-COMPACT HP-COMPACT V5.4 14/80 4 Control 4.1 Display and control parameters

STUDER INNOTEC HP-COMPACT HP-COMPACT V5.4 15/80 4.2 Light Emitting Diodes (LED) LED Marking LED lit LED blinks 1 AC IN Voltage corresponding to

STUDER INNOTEC HP-COMPACT HP-COMPACT V5.4 16/80 25 POWER MONITOR Display the value of the output power in % of Pnom (in Inverter Mode) and the char

STUDER INNOTEC HP-COMPACT HP-COMPACT V5.4 17/80 time, then it no longer switches on automatically. The LED 13 remains lit. Press the push button 19

STUDER INNOTEC HP-COMPACT HP-COMPACT V5.4 18/80 4.6 The battery charger 4.6.1 Cycle of charge The full automatic HP-COMPACT Battery Charger is adj

STUDER INNOTEC HP-COMPACT HP-COMPACT V5.4 19/80 carried out for 20 minutes (factory setting). During such a charge cycle the LED 14 is lit and durin

STUDER INNOTEC HP-COMPACT HP-COMPACT V5.4 20/80 The measure system built in the HP-COMPACT takes into account the battery voltage, the discharge and

STUDER INNOTEC HP-COMPACT HP-COMPACT V5.4 21/80 4.7.1 Set the transfer voltage threshold The voltage threshold of the transfer can be adjusted betw

STUDER INNOTEC HP-COMPACT HP-COMPACT V5.4 2/80 English description...

STUDER INNOTEC HP-COMPACT HP-COMPACT V5.4 22/80 − Over temperature (LED 10 lit) − Overload (LED 11 lit) − Over or less voltage of batteries (LED

STUDER INNOTEC HP-COMPACT HP-COMPACT V5.4 23/80 actual temperatures, a temperature sensor can be connected to the HP-COMPACT. The compensation throu

STUDER INNOTEC HP-COMPACT HP-COMPACT V5.4 24/80 5.2 Reset value (default settings) To come back to the default settings, press simultaneously on th

STUDER INNOTEC HP-COMPACT HP-COMPACT V5.4 25/80 5.3.2 Table of voltage and timing threshold The voltage levels (low voltage, float charge, end of c

STUDER INNOTEC HP-COMPACT HP-COMPACT V5.4 26/80 like this the Auxiliary Contact works with the lowest set condition and stops when it has reached th

STUDER INNOTEC HP-COMPACT HP-COMPACT V5.4 27/80 5.5 Disabling some of the HP-COMPACT functions Each different function charger, inverter and transf

STUDER INNOTEC HP-COMPACT HP-COMPACT V5.4 28/80 8 Technical Data

STUDER INNOTEC HP-COMPACT HP-COMPACT V5.4 5/80 English description 1 General Information 1.1 Operating instructions This manual is part of the deliv

STUDER INNOTEC HP-COMPACT HP-COMPACT V5.4 6/80 1.4 Liability Disclaimer Respecting this manual, servicing and method of installation, functioning, a

STUDER INNOTEC HP-COMPACT HP-COMPACT V5.4 7/80 − Plenty of fresh water and soap must be ready at hand so that in case of acid coming in contact wit

STUDER INNOTEC HP-COMPACT HP-COMPACT V5.4 8/80 connection between Neutral and earth in inverter mode only may be done by installing a bridge interna

STUDER INNOTEC HP-COMPACT HP-COMPACT V5.4 9/80 2.3 Battery connecting Lead-acid batteries are normally available in blocks of 2V, 6V or 12V. In most

STUDER INNOTEC HP-COMPACT HP-COMPACT V5.4 10/80 3 Mounting and installing 3.1 Installation place The location of the HP-COMPACT must be driven by t

STUDER INNOTEC HP-COMPACT HP-COMPACT V5.4 11/80 A Battery +/- Connection terminal (M8) for battery cable (HPC 4400-24/6000-48/8000-48 with fuse)